If you can’t remove the oil filter element, you can directly destroy the circular section of the lower side of the filter and release the waste oil, and then use a wrench to rotate it down. The specific steps are as follows: 
1. First, we need to start the vehicle for about 1 minute to allow the oil to flow fully, and then turn off the engine. Then open the oil filler cap and use a tool to loosen the screws on the oil filter and oil bottom;
2. Then, place the oil basin under the oil bottom screw, loosen the oil bottom screw completely, and let out the old engine oil until it stops flowing at all. Be sure to turn your body sideways when you put the engine oil. Many people who have just learned mechanical repair will always get the engine oil on themselves, so pay attention;
3. Next, tighten the oil bottom screw and wipe off the excess oil with a cotton cloth. Unscrew the old machine filter, it is recommended to put a cotton cloth on your hands carefully, apply engine oil to the seal ring of the new machine filter, and tighten it in a clockwise direction. Then add oil, add new oil from the oil filler port. As for how much to add, it is recommended to consult your local 4S shop in advance, and tighten the filler cap after adding it;
4. Finally, restart the engine for 12 minutes, and observe whether the oil bottom screw and the machine filter are leaking. If the oil leaks, the engine should be extinguished in time and checked. If there is no oil leak, check the amount of oil on the oil dipstick after the flame has been extinguished, and add it to the position above the center line of the oil scale at the standard position, and the replacement is completed.